Posted by RN on October 09, 2012 at 18:27:42 from (97.88.242.90):
In Reply to: O/T Its getting close posted by lyle niemi on October 09, 2012 at 13:46:12:
So if walls are up and roof is next to them, and you have slanted ramp boards, lots of rope, pulleys and a tractor handy you can hitch rope to braced side of roof and pull it up slanted ramp, then over top plates of walls to close to finish location. pry bars for final locating, then nail down to center, then some bolts in predrilled holes in top plates to end of rafter or rafter ties. Amish do this with horse teams when moving or repairing storm damaged roof structures or sometimes working up new buildings when prebuilt trusses are used as a base for ground finished roof. Tilt roof with jacks to get clearance for a brace/rope or chain attach beam, ramps, brace end wall and pull. Alignment beams/boards guide roof onto walls in proper place, lag bolts to roof from underneath through the top plate-as noted predrilled pilot hole- and you have it tacked in place for final hold downs.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Harvestin Corn in Southern Wisconsin: The Early Years - by Pat Browning. In this area of Wisconsin, most crops are raised to support livestock production or dairy herds in various forms. Corn products were harvested for grain, and for ensilage (we always just called it 'silage'). Silo Filling Time On dairy farms back in the 30's and into the first half of the 40's, making of corn silage was done with horses pulling a corn binder producing tied bundles of fresh, sweet-smelling corn plants, nice green leaves with ear; the
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
