Posted by Long560 on October 04, 2012 at 12:05:00 from (72.251.20.168):
In Reply to: Re: torque specs posted by welding man on October 04, 2012 at 10:02:18:
thank you so much for the reply and the tip on the retorque.i got in touch with someone at longparts where i bought the parts that could speak good english and got the specs.the only other spec i needed was the rod and they say it from 82-88. i bought this old tractor out of a brush patch and im doing a patch job on it.the milkey oil has me spooked.im not sure if it was uncovered and rained in it or if theres a internal leak somewhere that will open up when it gets hot.i pulled the pan and pumped the radiator to 20 lbs of pressure and could not see any leaks on the inside.i did have it running and found out that #2 was dead which turned out to be a cracked piston.the previous owner said it died and wouldnt start and a neighbor laid the either to it trying to get it to prime up im guessing thats where the cracked piston came into the picture so im replacing it and crossing my fingers.i blew out the secondary fuel filter to get it to crank and i think that may have been all that was wrong with the tractor. thanks again for the reply.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - My Ford Golden Jubilee - by Troy Estes. This article is about my '53 Ford Jubilee and a story that starts with taking the tractor to my brother's Starter/Alternator Rebuilding shop for a wiring fix. The generator was shot as well as all the wiring. I dropped off the tractor expecting a transformation from a 6 volt to a 12 volt system utilizing the original generator housing, and a total rewiring of the whole tractor. The front end center pin bushing was worn also so I ask that they replace it if they had time. Well, that’s wha
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
