Posted by Bobl1958 on October 02, 2012 at 12:58:00 from (68.98.205.31):
Posted on Using Your Tractor as well, but just wondering on the hydraulics on this JD 1560 drill and my White 2-135 tractor. The tractor has closed center hyds. The drill needs down pressure. The drill comes as a closed center system, but has an optional valve that can change from open center to closed center. If I understand right, I need to have it on closed center and then lock my remote lever forward (down)to keep the oil flowing through the drill hyd system and keep down pressure on the openers, etc. My problem is that it seems like when I hold the remote lever in the tractor forward, the hyd system seems to be growling, like I need to release the lever. I may be dreaming, but it sure seems like it. I don't want to burn the pump up or anything. Any suggestions? Also, the hyd pressure gauge has been changed out from the original gauge that has green, yellow, and red pressure zones, to one with psi. Any idea where the psi might be in normal conditions? Just an approximate to have something to go by. The JD750 drill I traded in had an entirely different set up. Thanks for any help. Bob
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Product Review: Lead Substitutes - by Mike Schordine. Lead was oriinally added to gasoline as an upper cylinder lubricant. It lubes the valves and seats. If you rebuild the motor, you could use hardened seats and valves, and unleaded fuel. But if your old tractor runs good, a simple lead substitute added to the gas is a perfectly reasonable solution. And, if you are like me, your tractor is under cover, but it sits outside. So with every temperature change, the humidity in the air collects in the fuel tank, in the form of water.
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
