Dave- As an old time farmer, I can't believe how lucky you are......low moisture corn, don't need to dry. Plus the yields you get on the soil you have. In 40 years, I had only some, one year, that didn't go through the dryer. Even if those bins have a spreader....cone them out after filling...ie....pull a load out to get the fines out of the middle. NEVER leave a bin go into winter with a peak on the crop....moisture migrates with temp, comes out the top...if the grain is peaked, moisture goes up the peak and rots the crop. Helps if you're feeding/selling some- pull out an occasional load. Can get by til Spring with 16-17% corn. I have a drying bin but dry everything with an automatic batch dryer after babysitting the bin dryer for years. I have full floors in two bins, 7 1/2 hp fans....freeze corn in the Fall (beans too), warm a couple times in Spring as the temp rises. Fan tubes you're talking about- you're half hour from St. Cloud, Mimbach, Mills Fleet? Without them, just move some crop every month......wagon or two keeps it fresh with the flow.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.