Posted by Tony in Mass. on September 28, 2012 at 19:54:36 from (76.127.225.182):
In Reply to: OT: steel cased ammo posted by KYfarm on September 28, 2012 at 04:11:29:
Probably just as well. got to remember steel cases are an iron curtain idea, for all the worn out much hated Russian and Chinese rifles, for a soldier to stay alive long enough to find a better gun. Steel on steel in the chamber, the bolt face- and the 'space age alloy' in your upper reciever is fine for Y3K or a zombie attack, but, not if your rifle is to last a long long time. Brass cases take the pounding rather than the expensive or irreplaceable steel parts. That's why some live to get reloaded, some got smashed keeping your rifle from getting smashed. And... if this stuff is from eastern Europe or Asia... if most likely has a corrosive primer, no swet with your chrome barrel, but the rest of the action would have to be field stripped and cleaned with solvent at the end of every shoot without fail. I have lived thru atleast 5 gun grabbin black helicopter, red hoard invasions, so I wouldn't be so impatient to not hunt down a stash of brass cased FMJ, or handload whatever brass and bullets you do run across. But you finding 32-20 brass is enough of a find to make my year, good going!
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Massey Ferguson 35 (and up) Tractor Assembly Notes - by Jack Wetmore. These assembly notes are for Massey Ferguson tractors with a two stage clutch and 6 speed, 8 speed and mutli-power transmissions. I see a lot of discussion forum messages regarding damaged clutches from improper assembly. The objective is to have the engine and transmission slide together safely and easily until the gap between the two halves is less than 1/4", BEFORE tightening any of the bolts holding the two together. Using bolts to draw the two halves together will damage the PTO
... [Read Article]
Latest Ad:
1 SD Gibson, 1 D Model needs rear end assembled and installed, 1 D Model needs minor repairs, extra parts
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
