Posted by Jon Hagen on September 26, 2012 at 21:28:47 from (69.26.17.61):
In Reply to: convert to alternator posted by C Kain on September 26, 2012 at 18:52:18:
Yes, the cutout is no longer needed and can be eliminated. The link below takes you to a good, simple, easy to understand wiring diagram and parts list.
I perfer using a charge light rather than a diode. The charge light serves as an indicator that 1 your alternator field circuit is working,2 your alternator is / is not charging,3 you forgot to turn off the ignition and will run down your battery.
Also, the indicator light serves as a current limiter and restricts the alternator excite load on the ignition circuit to aprox 1/4 amp, while using a diode will not limit current and will allow the alternator field to draw 3-4 amps, nearly doubling the amp load on the ignition circuit, which can cause a voltage drop and weak spark / hard starting.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - History of the Nuffield Tractor - by Anthony West. The Nuffield tractor story started in early 1945. The British government still reeling from the effects of the war on the economy, approached the Nuffield organization to see if they would design and build an "ALL NEW" British built wheeled tractor, suitable for both British and world farming.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.