Posted by Nancy Howell on September 25, 2012 at 08:57:31 from (144.162.48.145):
In Reply to: Nancy Howell posted by Stan - Florida on September 24, 2012 at 13:50:38:
Going to 1st Monday trade days? Canton is south of the farm and about 1.5 hrs east of Dallas.
Its been a while since I went, but not many bargains in the central area any more. If you make the effort to get to the booths in the outer areas, you can find some good bargains.
There is a separate area for animals called "Dog Alley". Its 2 or 3 blocks south of the main area. Been to Dog Alley one time. Broke my heart to see all the animals needing homes.
Lots of other shops close to the main trade days location, but they are mostly new stuff and pricey.
They used to have a website with aerial pics. If that"s where you"re going, check it out so you know where things are located before you go.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Ford Part Number Trivia - by Forum Participants. "Replaced by" means the part was superseded. All of my part books date back to 1964 and New Holland have changed some part numbers. They usually put the old Ford part number on the package. I was suppressed when I looked up the part number of the auxiliary drive shaft because for some reason the part number went through a radical change and it lost its "Basic Part Number". Ford part numbers follow the following rules. Most part numbers are in three parts. The middle part is called the
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.