I have a 7 ft. Massey Cut-Ditioner, It is a useful tool in making hay, here's what I have experienced. They are suppose to be able to cut grass and alfalfa, but I don't use it to cut because it tends to grind too much and the windrow lays tight to the ground and it won't dry, grinds too many leaves off alfalfa. To cut grass it has to be sharp and the grass has to be heavy or it doesen't cut and leave a windrow, just blows it out the back. I do. use it as a conditioner, cut with a 9ft. haybine and lay in a wide swath, skip a day and then run over it with this unit, it turns the swath and fluffs it and leaves a tall windrow, I have the shields adjusted narrow enough so I can bale from the windrow. It is the best hay drying machine I have ever seen, I wouldn't sell it for any amount of $$. Today I was chopping covering or bedding hay in the low ground where I haven't been in 3 years due to it being too wet, very slow going because its only designed for 35 HP. and will sheer the pin in a second, I'm using about 70 HP on it. But with a lot of patients it will make nice bedding out of canary grass, as I said the best use is for a hay conditioner in grass. By the way, the hammers are suppose to swing freely and the roller is only to keep it out of the ground.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - My Ford Golden Jubilee - by Troy Estes. This article is about my '53 Ford Jubilee and a story that starts with taking the tractor to my brother's Starter/Alternator Rebuilding shop for a wiring fix. The generator was shot as well as all the wiring. I dropped off the tractor expecting a transformation from a 6 volt to a 12 volt system utilizing the original generator housing, and a total rewiring of the whole tractor. The front end center pin bushing was worn also so I ask that they replace it if they had time. Well, that’s wha
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
