Posted by Bryan iniowa on September 17, 2012 at 16:53:38 from (209.252.175.31):
In Reply to: Re: Ford V 10 posted by JMOR on September 17, 2012 at 10:34:42:
2 valve heads up to 2003 will blow them out . Overtightend or not . Have seen virgins blow them . poor casting design /not enough threads . Couple different style inserts avail . I have standard and an "oversize" that will take care of them if they blow insert out,,and I have seen dozen or so of those in the shop. Usually back cylinders on pass side that blow . kills the coil pack also when they blow. $60-100 for coil . The 2003 and up 3 valve engines break plugs off . They are a pain. sommetimes I luck out , more often then not end up breaking 6 out of 8. Requires special tool to push part of plug down and then nother tool threads itself into plug shell allowing it to be pulled out with yet another tool . I have tried every which way , soaking , overnight , doing them hot, cold , impact , you name it ,,they will still break . Figure 4 hr job on 5.4 . Folks fall over when you tell them what it cost to change plugs on them .
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - A Towny Goes Plowing - by Anthony West (UK). I live in an area renowned for its rural beauty. Small fields with hedgerows and trees are common place, as are small hamlets with village greens and the odd duck pond complete with swans. The center of any village once the shop is closed is the old tavern. Rustic places with cheerful names like "The Griffin" "Red Lion" or "The Plough and Harrow" are found dotted around the country lanes all over the place. The warm glow of yellowish light can be seen for quite some distance at dusk, and
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
