Kirk, Oil furnaces are a BPITA. You need to change the nozzle and filter every year or two and adjust the spark rods.
Check to make sure you have the air adjusted correctly, damper, and .02 inches of vacuum at the inspection door.
Check to see is chimney isn't choked with soot from an improperly adjusted air mix.
Buy a digital CO alarm.
All else fails, seek professional help.
Most people only fix their furnace when it gets cold. Wait a few more weeks and you will find all HVAC people working overtime.
I got rid of oil 30 years ago. Went to natural gas. 12 years ago converted to electric baseboard.
There is no maintance with electric baseboard. No fan motors, no ignitors, no brain boxes, no filters, no explosions, no CO, no cracked heat exchangers, no heat loss in trunk lines, set different rooms at exactly the temp you want. I won't have anything but electric. Very cheap to install too. George
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - My Ford Golden Jubilee - by Troy Estes. This article is about my '53 Ford Jubilee and a story that starts with taking the tractor to my brother's Starter/Alternator Rebuilding shop for a wiring fix. The generator was shot as well as all the wiring. I dropped off the tractor expecting a transformation from a 6 volt to a 12 volt system utilizing the original generator housing, and a total rewiring of the whole tractor. The front end center pin bushing was worn also so I ask that they replace it if they had time. Well, that’s wha
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
