Posted by d beatty on September 16, 2012 at 07:29:28 from (24.12.128.253):
In Reply to: Truck mileage question? posted by Brett Helmkamp on September 15, 2012 at 18:22:17:
I agree with one of the others it should be put on a code scanner. You say the truck has a 135,000 miles on it. The life expectancy of an oxygen sensor is a 100,000 miles with some going bad as soon as 70,000 miles. I have a GMC 5.7 vortec that did the same as your Dodge on gas mileage. I had engine light come and go out twice (only 61,000 miles). Had it coded and both front o2 sensors coded bad. I had them replace all four O2 senors ( at $52.00 for 2 and $72.00 for the other 2) and mileage went back what it was before sensors went bad. Six months after replacing them one went bad and had to be replaced ( covered by manufacture ).
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Ferguson System Principal An implement cutting through the soil at a certain depth say eight inches requires a certain force or draft to pull it. Obviously that draft will increase if the implement runs deeper than eight inches, and decrease if it runs shallower. Why not use that draft fact to control the depth of work automatically? The draft forces are
... [Read Article]
Latest Ad:
1965 International Harvester McCormick Farmall cub tractor 2,500. Two owner tractor. My grandfather bought new in 1966, then we inherited it. Have all the paperwork original manual and all maintenance records. It starts and moves. Comes with underbelly mower, plough, and some other attachments.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
