You would need a variable voltage source to make the adjustments. (I posted the test specifications for a regulator a few days back. it is down about four replies.)
The problem I have found most common on these regulators that don't work and look like your example is poor connections between the components of the regulator. A bad connection may not show up just testing with a DVOM. With no load on the circuit it may test fine but with increased amperage load the connection may fail. Many times the problem is between the contact and the arm where it is attached.
This post was edited by Owen Aaland at 08:14:32 09/13/12.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Restoration Story: 1941 John Deere B Row Crop - by Anthony West (UK). The 1960's promise of white hot technology, to relieve us of the drudgery of everyday work and to replace it with increased leisure time has not materialised just yet....if anything most people are caught up in an ever increasing rat race, wishing that there was at least 36hours in a day!!!. The need for people to escape for periods of relaxation in an increasingly complex and pressured environment takes us into the realm of hobbies. For some it's scaling high mountains for others it's putting p
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
