Posted by gbs on September 12, 2012 at 16:53:01 from (68.115.197.190):
In Reply to: 6 volt issues posted by Brad Metcalf on September 12, 2012 at 14:05:24:
probably not your problem,but i put a rebuilt starter on an m years ago it would turn it over decent for about 3 rounds then start slowing down, nothing i tried seemed to help even hooked to 12 volts same problem,i noticed it was hard to turn before i installed it,pulled it back off turned ok by hand but was still tight,i loosened the 2 bolts a little that hold the starter together it freed up a lot, noticed the gap between end plate and field housing was wider on one than the other,the rebuild end plate had been bored out of line when being bored to accept and oversize bushing,replaced it with another one problem solved
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - History of the Nuffield Tractor - by Anthony West. The Nuffield tractor story started in early 1945. The British government still reeling from the effects of the war on the economy, approached the Nuffield organization to see if they would design and build an "ALL NEW" British built wheeled tractor, suitable for both British and world farming.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.