I'm working on the same idea--still on the drawing board--for an International truck six. Using the idea of 3 injectors, one in each intake runner...since the head is where the ports actually "split" for each cylinder. You simply have to make each injector fire EVERY crank revolution, instead of every OTHER crank revolution. On a low-rpm engine like a tractor or some of these old trucks, firing each injector twice as often still shouldn't be too bad on them.
Remember, it takes TWO crankshaft revolutions to make a combustion "cycle" on a 4-cycle engine...so on your 4-cylinder example, you'd be firing one injector every 180 degrees, since it would take 720 degrees--two crankshaft revolutions--to fire all 4 cylinders. At 90 degrees of crankshaft rotation, there should be NO spark OR injector events going on...think about it.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Reflections of the Fifties - by "Country" Elliott. I remember rowing up in the 1950�s in a small, rural town in northwestern New Jersey. The closest town to ours was only 3 miles away, and there were seven dairy farms in the areas of these two country towns. We had 5 acres, and because my Dad was a salesman and not a dairy farmer, he let the Bockovens, who owned the Willow Tree Dairy farm most of our land.
... [Read Article]
Latest Ad:
1 SD Gibson, 1 D Model needs rear end assembled and installed, 1 D Model needs minor repairs, extra parts
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
