Posted by Andy C on September 03, 2012 at 07:33:46 from (72.94.18.55):
In Reply to: 7700 JD 3 point posted by LazyWP on September 03, 2012 at 06:23:01:
Worked on a 7600 one time with the same issues. (dealer said they needed new cylinders)I disconnected cylinders and it would not go down. Many hours later I got the rockshaft freed up and moving. It was a long while ago but as I recall I was able to move the shaft sideways slightly and then Small movements up and down then finally full movement. It rides in bushings and water had gotten in and done its thing. I almost drilled the casting on the outside to install grease fittings but was not sure what the inside of the casting was covering so I did not. I did however never seize as much of it as I could expose and periodically cleaned and lubricated it.I don't know if this is your problem or not but I have heard of others having the same issues. Good Luck, Andy
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Trailering Your Tractor - by Curtis Von Fange. One of the fun things of summer and fall are the parades and tractor shows that go on across America. Many owners of tractors travel long distances to attend these shows and they usually take their restored iron along with them. Safe trailering practices and inspections will ensure that the event is a fun one. A good habit to develop when using a trailer is to give that �quick look over� before taking it on a trip. Before hooking up to it check the tongue for proper operation. The latche
... [Read Article]
Latest Ad:
1965 International Harvester McCormick Farmall cub tractor 2,500. Two owner tractor. My grandfather bought new in 1966, then we inherited it. Have all the paperwork original manual and all maintenance records. It starts and moves. Comes with underbelly mower, plough, and some other attachments.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
