Posted by Dick on September 01, 2012 at 20:10:59 from (66.78.69.150):
In Reply to: this was weird posted by wilko on September 01, 2012 at 13:25:54:
Went to look at a baler last year, it looked good and I made and offer that was accepted. Told the guy I would give him a check, BUT, I wouldn't pick up the baler until I was down this way again. Told him that way the check would have plenty of time to clear. No problem he said. A couple of weeks later I was in the area and stopped by hooked the baler and towed it home. I wouldn't have expected him to turn loose of the baler with my check in his hand. Other times, on smaller purchases, I have told the seller I've had this checking account for 40 years and never written a bad check, if it does bounce I'll pay them double. I show them my drivers license and any other form of ID so they know the name on the check matches. Never was a problem.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Measuring with Calipers - by Staff. The legs of inside calipers are curved outward at the extremities to facilitate measuring small holes, while outside caliper legs have a large curve inward to increase their capacity for large work. Firm-joint calipers are adjusted approximately by the hands and then set to the feel of the work by tapping them on a metal surface. It is a common practice when opening calipers by this means to tap the top of the joint. It is better, if possible, to tap the inside of the legs, as repeated blo
... [Read Article]
Latest Ad:
Late 50s early 60s international harvester 560 with cultivator
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
