It just depends on what they do. "Scoping" is the type of surgical process - going in through small incisions rather than a big one. I've had knee surgery both ways. There are a lot of different procedures they do orthroscopically or however it's spelled. I was in an immobilizer and on crutches for several weeks when I had my knee "scoped". They did more than they usally do that way hoping to avoid a major rebuild later, but it didn't take and I had it cut all the way open and major work done a couple years after. THAT sucked, especially the part where after literally not bending my knee for 6 weeks or so and having it sliced and diced and screwed, I slipped on the ice and folded it underneath me. No damage, but it hurt like nothing I'd felt before or have since, and my response to someone calling me a pansy and faker nearly got me kicked out of school. He was lucky I couldn't walk, lol.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
