Posted by Dell (WA) on August 24, 2012 at 09:42:49 from (63.226.209.134):
In Reply to: 8N digital gauge posted by Krwkmt on August 23, 2012 at 17:55:45:
Krwkmt.......surprizingly enuff, digital gauges don't like sparkies. And without sparkies, guess what??? Engine NO RUN. And even worse, yer 8N's weaksister ignition needs COPPER-CORE sparkie wires which generates sparkies to kill yer digital meter. While you "might" gitt some sparkie relief iff'n you use modern resistor carbon-core sparkie wires, it is NOT RECOMMENDED. Me? I use a tube operated mechanical temp gauge from Stewart-Warner (print matches other gauges) and the sparkies never bother it. ........mechanical Dell, retired electronics engineer
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Massey Ferguson 35 (and up) Tractor Assembly Notes - by Jack Wetmore. These assembly notes are for Massey Ferguson tractors with a two stage clutch and 6 speed, 8 speed and mutli-power transmissions. I see a lot of discussion forum messages regarding damaged clutches from improper assembly. The objective is to have the engine and transmission slide together safely and easily until the gap between the two halves is less than 1/4", BEFORE tightening any of the bolts holding the two together. Using bolts to draw the two halves together will damage the PTO
... [Read Article]
Latest Ad:
1 SD Gibson, 1 D Model needs rear end assembled and installed, 1 D Model needs minor repairs, extra parts
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
