What are the tasks or work is a tractor expected to perform under your control? Purchasing a tool to then trying to fit it to the job vs purchasing a tool that is cabable to perform the job. Saves times, money , injury and death. For the little piddly bit of fuel any of these tractors would burn. Fuel efficiency is the least concern. As previously stated or alluded to. Your age, ability, desire to chase down or build/re-build obsolete parts? Your shop facilities? The distance to a dealer that gives a care and can obtain parts? Nobody can afford new but repairing a worn out broken and abused machine that fails and leaves the work undone costs even more. With the state of the market. There are scads of decent fords, IH, Oliver, Massey etc. With 12V alternator systems, live pto, hydraulic scc"s, a real three point hitch, a real drawbar, live hydraulics and decent brakes. For little $ more than the first tractors that replaced the horse. Depending on the local shop rates. It"s all to easy to purchased used , make repairs and in 10 years spend more $$$ and less of an asset vs Just purchasing something new with the low interest and factory promotions.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.