Posted by wjkrostek on August 21, 2012 at 09:04:57 from (72.35.102.204):
In Reply to: Re: yanmar 22d posted by Diydave on August 21, 2012 at 03:06:16:
I'm smart enough to ask what other people think anyway. I may not listen but I'll ask. 4 wheeler just don't have the ground clearence needed so instead they use speed and churn it up. After a day or two no one uses the trail because it becomes work. it's not like they are bottomless pits. You normally only sink to your knees. the little tractors don't look like the weigh much and should be as whenchable. One other problem is the woods and bogs are full of logs and sticks that might rip your tires. How unstuckable is your tractor? If you can walk through it without a stick you then think you can make it. Just thinking. Also with the holes in the rims I can chain a log to the tire to get me one or two feet at a time. Other thing which ones have a locking dif?
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.