Posted by ericlb on August 16, 2012 at 04:59:08 from (75.107.64.57):
In Reply to: WAY OT-- 79 F150 posted by 5020s rock on August 16, 2012 at 03:39:24:
3 1/2 is right otherwise your going to be doing u-joints every other weekend, this assumes your using a spring type lift kit, which changes the driveline angle, do not rotate the axle tubes to reduce u-joint angle or you'll be running the pinion bearings dry! you can gain additional clearance by using a body lift kit which raises the body off of the frame, as well as using bigger tires, remember though the higher you go, the less stable and worse handling the truck will be at speed on road, there is a point at which you will have to dedicate the truck to either on road, or off road use, i made that trip myself as a youngster, bob chandler had just rolled out the first bigfoot, and we all wanted to be him lol i had a 75 ford , wound up with 6 inches of total lift, with a body and spring lift installed, this was about as big as you could go back in the day had a set of 36" supper swampers in it, the truck was cool, and a chick magnet, off road it was a lot of fun, on the hiway OMG! this thing was a nightmare at anything over 45 mph, it was all over the place,had to take a corner like a cj-5 jeep would have to, and hiway speed wore those 36 inchers out quick, plus it felt like driving a backhoe down the road with the bucking sensation it had, there has been a lot of improvement thru the years in lift kits compared to what we had back then, but if your going to head the truck up in the air, think it out, and plan carefully
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - What Oil Should I Use? - by Francis Robinson. I keep seein this question pop up over and over again in discussion groups all over the web. As with many things there are often several right answers and a few wrong ones. Some purist I'm sure will disagree to no end with what I will tell you but most of us out here in the real world don't really care do we ? Some of them only bring their noses down out of the air long enough to look down them anyway. If you are like me you are only doing this old tractor stuff because you enjoy it. You
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
