Posted by jfharper on August 14, 2012 at 09:17:42 from (173.255.107.30):
I'm doing some conversions on my power steering system and was curious about some things.
If the pressure port out of my power steering pump is a 1/4" NPT port, that would mean the ID of this port is 1/4." Then a 3/8" tube/hose assembly attaches to this port's fitting and goes into my steering control valve.
The control valve pressure inlet port is -06 oring straight thread, so according to the -06 fitting, the OD is 3/8", making the ID somewhat smaller than 3/8 due to tube wall size, but larger than 1/4.
So my question is, since the port on my pump is 1/4" ID, I should be safe in going no smaller than -06 or 3/8" tubes and fittings on the rest of my system...correct? I just wanted to make sure my system didn't need -06 or -08 somewhere, like at the steering control valve pressure inlet for pressure/flow purposes, because if the pump pressure port is 1/4" than that right there is the flow limiting link in the chain...right?
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Bad Vibes - by Curtis Von Fange. One of the strangest ways to communicate with our tractor is to ask it how it feels. "Ask it how it feels," you say? Yup, ask it how it feels. Now, as with the other articles in this series one has to be able to hear what 'ole blue' is trying to say in response. The nice thing about our old iron friends is that they are usually quite consistent in their response, rather unlike some people I know who might change what they say due to the weather or other mitigating circumstances. But since t
... [Read Article]
Latest Ad:
1965 International Harvester McCormick Farmall cub tractor 2,500. Two owner tractor. My grandfather bought new in 1966, then we inherited it. Have all the paperwork original manual and all maintenance records. It starts and moves. Comes with underbelly mower, plough, and some other attachments.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
