Posted by JDseller on August 12, 2012 at 07:49:42 from (208.126.196.144):
In Reply to: Re: OT Hwy Laws posted by 730d se on August 12, 2012 at 06:21:42:
730d se: the reason the semis block the merging lane is the idiots/drivers that are "special" and roar right down to the merge point rather than merge sooner. Most times on the free way system blocked lanes will be marked miles in advance. Do think the average car driver will merge anytime sooner than the last fifty feet???? Heck NO they are special!!! SO the ones that do merge early have to wait for the idiots the go "first". The semi drivers have agreed that the one blocking will be let back in the merge lane when then need too. It makes the traffic move faster because there are not fifty idiots waiting to merge at the merge point.
I was in PA on I-80 one time. They where rebuilding the entire east bound lane. You had to merge and cross and run two lane for miles. At the merge point there had been many accidents. Several fatalities. Idiots trying to merge too fast in the last fifty feet. Cutting the traffic off. The local state Police Captain put ten cars in the last mile. They wrote anyone a ticket that had not merged before the last distance. They wrote over 900 tickets in two days. The ticket was for improper lane changing. The local court had agreed in advance to not let any of the drivers out of the ticket. The ticket was for $175 each. It worked pretty well. They would crack down about once each month and the drivers seemed to remember how to merge a lot better. There was not another fatal accident at that merge point after that.
They did post signs miles back about when to merge and what the penalty would be. Still wrote a lot of tickets to the "special" people/drivers.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Ford Part Number Trivia - by Forum Participants. "Replaced by" means the part was superseded. All of my part books date back to 1964 and New Holland have changed some part numbers. They usually put the old Ford part number on the package. I was suppressed when I looked up the part number of the auxiliary drive shaft because for some reason the part number went through a radical change and it lost its "Basic Part Number". Ford part numbers follow the following rules. Most part numbers are in three parts. The middle part is called the
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.