You know, somebody else posted about similar technology yesterday, and its probably a good idea. I have to figure that the best way for Oliver to lay this out, is all of the 3/4" first, and then the smaller 5/8". Somewhere in there, probably half way, or at the 5/8", the electric pump to act as a repeater to reenergize the water flow, either by sucking, pushing, or both. There is naturally going to be friction inside of the hose, becoming more evident at that length, and since hose is rubber and gives, the hose nearer the spiqot is going to contract and expand as the flexable rubber gives into pressure caused by both friction and size reduction, reducing the volume output.
But, Oliver, if you are going to get that 1 1/4" in, don't waste money on the pump, until you find out that a 1 1/4" pump as a repeater is what the doctor ordered on your pipe, after the pipe is in, and you see a need. Money aint easy these days with crops failing as bad as the economy in general. Don't forget a way to drain the pipe at the low points, unless buried, and then at the lowest point. Broken frozen shallow pipe, not what the doctor ordered for the pocketbook or self esteem.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Talk of the Town: The Saga of Grandpa's Tractor - by The following saga is from the Tractor Talk Discussion Forum. Someone. The saga starts with the following message: Hey guys I have a decision to make. I know what you all will probably suggest and it will probably agree with me way down inside, but here it is. I have a picture blown up and framed in my "tractor room" of a Farmall M. It was my Grandpa's tractor, of which whom I never got to meet. He froze to death getting this tractor out of the barn to pull a truck out of the ditch before I was born. Anyway my dad and aunt had to sell it at the auction,
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
