Sorry for the additional post, but I think I did not articulate the reasoning behind shooting close and not using a "bull". The practical reasoning is that when learning, immediate feedback is essential. Remember that building of motor skills requires feedback (just like feeling bolt torque with a wrench). As the shooter becomes more comfortable with his skills, continue to move the target. I always practice this drill whether with handguns or rifle (mind you because of the skill level, I shoot smallbore at 50 feet, even using a Walther KK300 it is quite a challenge for me to stack the shots). The biggest advantage that I have found when teaching this way is psychological. If the shooter cannot get immediate feedback from the shot, he does not know whether what he did works or not. I found that when a new shooter has to go forward to check shots and finds that he did not hit what he wanted, he becomes very discouraged. This, I believe is very true especially for children--they want to perform and do well; trying to please us. Remember, part of our job, ESPECIALLY when teaching shooting skills is to build THEIR confidence. I use this drill when teaching new shooters pistol and I can usually have the shooter engaging 12" plates at 100yds after about an hour or so (BTW--anyone can do that with a pistol, there is no secret).
As stated earlier, dry firing is the best and cheapest practice, but I urge people not to dry fire a rimfire unless it is a Kimber or CZ. Damage to the chamber or firing pin is likely to occur.
Like everyone else said, enjoy and have fun with it. Experiment with different challenges, make up your own games to play. Not only are the sessions mean to teach skills, but they are your special time together. Also, if I may, never say "do it this way", always use "try this--". Also, try not to use the words "don't, no, or especially 'miss'". Always use "do, yes, shot and hit".
Again, everyone's input is spot on especially with have fun and enjoy your time together.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Uncle Cecil's Super A Lives Again - by Mike Purcell. A week or so out of most of my childhood summers was often spent with my Uncle Cecil and Aunt Sissie in the small East Texas town of Maydelle on their 80 acre farm. Some of my fondest memories of these visits are those of learning to drive a tractor at the helm of Uncle Cecil�s 1948 Farmall Super A. Uncle Cecil was the second owner of this wonderful little tractor, but it was almost as though he had adopted an infant. The original owner was a man from Minnesota who bought her from a local dea
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
