Posted by Texasmark1 on July 05, 2012 at 13:22:03 from (67.142.164.20):
In Reply to: Another AC Question posted by 8N'r--WI on July 05, 2012 at 04:57:45:
The most efficient system is one that runs continuously at the worst heat load. Reason is that all the heat pockets have been eliminated. Air is circulating, freon is flowing, effect of duct heat absorption from the attic is minimized, condenser is receiving cooling air, and maximum moisture is being removed which in itself improves comfort....cool dry air is much more comfortable than hot humid air....ala the Gulf Coast, Texas, Florida....BTDT and I went to school on the subject. Every time your AC cycles, it has to start the averaging process all over and those delays cost you money in addition to the start up current surge.
That's one of the neat things about room AC's the cooling loop is right there in the unit and there is no attic heat load to consider. Additionally, the room AC routes the condensed moisture (water) from the room to the rear of the AC where the condenser coil is located and a slinger ring on the condenser fan blade, slings this water onto the condenser coil and you enjoy the added efficiency of the "heat (removal) of vaporization" which your central unit doesn't have and costs you that much more money.
I built my house with my family by hand 30 years ago on that concept and my light bill last month was about $70 and this month was about $95 and I live in N. Texas....had a lot of 90 thru 100+ degree days in this months cycle.....hot water and cooking are gas. I have a 2400+ sq. ft. house.
So if some AC replacement guy wants to sell you a 5 ton AC for a 1000 sq. ft insulated home in the USA, run him off....unless you have 6 kids and they are in and out all day and leave the doors open and all that stuff.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Sunday Drives - by Cowboy. Summer was finally upon us here in Northern Maine. We have two types of industry up here, one being "Forestry" (Wood Products) and the other "Farming" (Potatoes). There is no shortage of farm tractors and equipment around here! I have been restoring old Farm Tractors for the past 6 years, and have found it easier and less expensive to hit all the auctions and purchase whole tractors for parts needed. My wife who works at a local school, and only has weekends and summers off, while on t
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
