Posted by Dave SE Mich on June 24, 2012 at 19:57:56 from (64.112.217.205):
In Reply to: disapointing posted by casenut1 on June 24, 2012 at 16:48:40:
My wife and I got there just before noon,the parking lot was fairly full, first thing was the noon steam engine whistle blow by maybe 50 plus engines. Lunch was next and decal purchase for an Oliver plow and another vendor made signs for my Case 730 that my wife picked up later. We each looked around on our own and then meet in the grandstands to watch kids and adults play tug of war with steam engines. Next was a wagon ride pulled by a road steam locomotive out to a field to watch horses, tractors and steam engines plowing. At 4 PM we were back to the grandstands to watch the steam engine and tractor parade. Next I looked at tractors, talk with some friends and my wife spent some time in the flea market. Also I watched the saw mill cut up 2 large logs and for fun tractor pulling was also going on. We meet up again, ate again, listened to some Blue Grass Band and headed home about 8:30.
Yes the number of Massey tractors ( featured tractor )was low, but I got to see 2 of the four wheel drive tractors Massey made in the 30's, one had been out in the field pulling a cultivator earlier. Frick steam engines ( featured )seem fairly rare, some of them at the show were made before 1900 and looked great. We be back again next year.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - My Ford Golden Jubilee - by Troy Estes. This article is about my '53 Ford Jubilee and a story that starts with taking the tractor to my brother's Starter/Alternator Rebuilding shop for a wiring fix. The generator was shot as well as all the wiring. I dropped off the tractor expecting a transformation from a 6 volt to a 12 volt system utilizing the original generator housing, and a total rewiring of the whole tractor. The front end center pin bushing was worn also so I ask that they replace it if they had time. Well, that’s wha
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
