Posted by ericlb on June 09, 2012 at 04:37:30 from (75.107.64.57):
In Reply to: john deere mower posted by 766ih on June 08, 2012 at 21:03:27:
the only way to tell is pull the part with the bad bearing, if its a spindle you should be able to buy a bearing, if you can see the number on the bearing a good auto parts store can get it, if they dont have it already most of these use a common bearing, if its on a idler wheel it may still be available but its going to be a lot harder to change, most are made by riviting 2 stamped halves togeather, with the bearing inbetween the halves, youll have to drill out or grind off the rivits taking great care not to damage the stamped steel pulley at all, replace the bearing, then using grade 8 bolts that are exactly the same diameter as the hole in the pulley and as short as possible, while allowing the nut to fully engauge the threads on the bolts [ use locknuts this is critical] put the 2 halves back togeather, keep in mind that if the old bearing has steel seals over the balls you must use the same style, plastic seals may melt from heat
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - What Oil Should I Use? - by Francis Robinson. I keep seein this question pop up over and over again in discussion groups all over the web. As with many things there are often several right answers and a few wrong ones. Some purist I'm sure will disagree to no end with what I will tell you but most of us out here in the real world don't really care do we ? Some of them only bring their noses down out of the air long enough to look down them anyway. If you are like me you are only doing this old tractor stuff because you enjoy it. You
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
