As long as it is long enough to be cut to fit yes it would work just fine. Then you need to know how to time it or it will not cut much if any thing. To time a sickle mower you move the pitman drive to the closed position and the bar to the inner position and measure for the stick and then move every thing to the outer position and remeasure to be sure you get the same measurements. Then fun fun begins. You then have to drill the holes in the stick and get all that set up
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Grain Threshing in the Early 40's - by Pat Browning. The setting is rural Wisconsin, halfway between East Troy and Elkhorn, on Hodunk Road, our nation was at war, and I was 6, 7 and 8 years old. George was our "threshing neighbor." He was the one with the threshing machine, a JI Case on steel wheels, and he pulled it to our farm with a JI Case standard tractor also on steel. In those days, steel wheeled implements were common. The roads were general gravel, so the lugs cutting into them wasn't a problem. George would set up the thresher, s
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
