Posted by JDseller on May 23, 2012 at 08:01:52 from (208.126.196.144):
In Reply to: Re: 4020 posted by Mark-Mi on May 22, 2012 at 20:09:58:
Mark and David below. THERE IS not any "fuel" screw on a JD 4020 of any age or model. They all would have had a Roosa Master injection pump on them. NON of them would have had an external fuel adjustment. The big in line Bosch pump does but that model pump was never used on a JD 4020.
Guys make sure of the advice you give a fellow. I have seen guys ruin their Roosa Master pump by breaking the pump head mounting/retaining bolts. These bolts sticks right up on the outside. The guy turns the "H" out of it and when he does not get any more power he turns it some more. Then it breaks and the head comes loose with a broken bolt in the fuel head. Injection pump repair time.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Harvestin Hay: The Early Years (Part 2) - by Pat Browning. The summer of 1950 was the start of a new era in farming for our family. I was thirteen, and Kathy (my oldest sister) was seven. At this age, I believed tractor farming was the only way, hot stuff -- and given a chance I probably would have used the tractor, Dad's first, a 1936 Model "A" John Deere, to go bring in the cows! And I think Dad was ready for some automation too. And so it was that we acquired a good, used J. I. Case, wire tie hay baler. In addition to a person to drive th
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
