Just went through something like that. Got a Karcher (sp?) and I even stopped at a small engine place to have it looked at, they suggested I go to a specialist. Oh boy, mine is a 2400psi from Menards, not a high end unit, didn't know if I wanted that much invested....
So I typed in the brand & model number in Google, and there were several hits that described my problem to a T.
One even had drawings to show how to fix it. Basically the pressure release valve gets gunked up with calcium/iron and doesn't slide. Take it apart & put grease on it and works great. Took me longer to read on the internet than to actually do it.
Mine would flow water through it, but would not build up hi pressure - I'd have to take the nozzle off and flow water, put nossle back on, and _then_ it would work - one time. any time I stopped the water flow, would have to remove nozzle, let water flow, and then it would go.
I think your problem can be related to that valve, but I won't say for sure - could be sticking in the other position and not letting anything happen.
Or perhaps your trigger valve is messed up similar, have you tried it without the trigger attached at all? You can replace them pretty cheap. (Edit: Kinda sounds like this, re-reading your message.....)
But type in the brand & model # to google, and 'no flow' or some such, and I bet you will get help on your exact problem.
I understand if you take the wrong part apart you have a mess and maybe lose a lot of high-dollar oil; so I'd want to follow some instructions that pertain to your model.
My deal was very very easy, pull off a cap, take 2 toex screws out, pull a plastic housing off, pressure up with water, find the valve that flew out, lube it with grease, and put back together. A caveman could do it. Just needed to know what pieces to take apart.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Sunday Drives - by Cowboy. Summer was finally upon us here in Northern Maine. We have two types of industry up here, one being "Forestry" (Wood Products) and the other "Farming" (Potatoes). There is no shortage of farm tractors and equipment around here! I have been restoring old Farm Tractors for the past 6 years, and have found it easier and less expensive to hit all the auctions and purchase whole tractors for parts needed. My wife who works at a local school, and only has weekends and summers off, while on t
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
