Posted by Bruce from Can. on May 19, 2012 at 03:14:07 from (70.29.128.72):
In Reply to: Roto-Baling posted by tommy_harrell on May 18, 2012 at 18:58:38:
Looks good to me. My dad bought a Roto baler in1948, and baled hay with it till 1988. Always kept inside, and put new belts on in aroud 1986. Only baler he ever needed,and he would make 4-5000 balesever year. Dad wold just cut in the morning, then go and rake an earlier cut field and bale in the afternoon. We never picked up a bale till all the baling was done for the year. Then we would go at it when my brothers and I where home , 3 sometimes 4 of us and dad, two or three wagons, and you would be suprised at how fast you could clear off a field. I mostly worked in the mow, with Dad on the elavator, lots of fun and good memories. Mom always had a roast beef or pork noon meal for us with lots of pie, and late in the afternoon Dad would always come up with a few beers. My folks are long gone now and my brothers are in their 60's. I still farm, and have the Alis tucked away in a shed, should drag her out , won't count on my big brothers to come help , maybe with some of the beer drinking,Ha Ha. Bruce
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.