Posted by George Marsh on May 16, 2012 at 13:19:57 from (50.104.198.217):
Today, I decided to think inside the box, instead of mowing the yard starting outside and working my way inward. I have 2 half acre rectangular yards with no trees or obsticles to get in the way. I mow with a 6 ft rear mounted woods finsih mower. Started mowing the yard down the middle and when I got an equal distant from the sides and end of the yard, I turned around. Did the same at the other end. When I finished mowing the yard looked like an oval shaped rug. There are two upsides to doing it this way. One is you are making large turnes at the ends and not making four 90 degree turns each round. Less work on the driver. The second upside is making a 90 degree turn the rear mower slides sideways leaving lots of grass to clean up in the corners. Try it, you may like it as much as I do. George
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - History of the Nuffield Tractor - by Anthony West. The Nuffield tractor story started in early 1945. The British government still reeling from the effects of the war on the economy, approached the Nuffield organization to see if they would design and build an "ALL NEW" British built wheeled tractor, suitable for both British and world farming.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.