Posted by holt_2ton on May 11, 2012 at 13:28:57 from (72.11.8.85):
Trying to rebuild one of the main lift cyl. on my "64 Ford 4000 loader(Wagner-Superior). It is a single acting WELDED cylinder. I got the packing nut off the end and the stack-up of packings out. BUT, I cannot get the snap ring out of the bore. It"s about 2" down and does not have any way to pry one of the ends down/out. The ends are square cut and no other notches anywhere else. The end nut compresses the packings against this snap ring and gland that it holds in place. I tried to push this gland back but it won"t budge. Which makes sense because the packings are compressing against this and so there has to be a shoulder there that won"t allow it to move any further in. Also, the way this ring is in there it is somewhat captured by this gland. Is this a non-serviceable unit? HELP!!
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Sunday Drives - by Cowboy. Summer was finally upon us here in Northern Maine. We have two types of industry up here, one being "Forestry" (Wood Products) and the other "Farming" (Potatoes). There is no shortage of farm tractors and equipment around here! I have been restoring old Farm Tractors for the past 6 years, and have found it easier and less expensive to hit all the auctions and purchase whole tractors for parts needed. My wife who works at a local school, and only has weekends and summers off, while on t
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
