I'm glad you guys think the OP has an equipment-$#!tting dog...
With a name like "Fergienewbie" I bet he's got an old Ferguson utility tractor with a two-bottom moldboard plow and a light 3pt disk at his disposal.
If he's got a heavy offset tillage disk and a big tractor to pull it, bully for him, but I'm betting not.
Fergienewbie, in the make-do category, try to wait until its a little wet and then disk the snot out of it.
If you can adjust the angle of the disk gangs, set them for maximum angle.
If you can add weight, add as much weight as you can stand.
If you have an old I-beam, pipe, or even a heavy log 6-8' long, chain that to the back of the disk and drag it along behind to bust up the clods and smooth things out better.
Get it smoothed out as best you can and then plow it again. This time get the plow digging evenly front to back, side to side. If you can't make it work, bail out. Don't root up the whole thing and make a mess out of it again.
This post was edited by mkirsch at 13:10:15 05/09/12.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Usin Your Implements: Bucket Loader - by Curtis Von Fange. Introduction: Dad was raised during the depression years of the thirties. As a kid he worked part time on a farm in Kansas doing many of the manual chores. Some of the more successful farmers of that day had a new time saving device called a tractor. It increased the farm productivity and, in general, made life easier because more work could be done with this 'mechanical beast'. My dad dreamed that some day he would have his own tractor with every implement he could get. When he rea
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
