Posted by Todd Hovick on May 08, 2012 at 08:05:59 from (70.41.159.83):
In Reply to: Broke easy-out???? posted by greg1959 on May 07, 2012 at 19:07:34:
I found out the hard way on a snowmobile cylinder where the stud broke off, then an easy out broke off, with the alluminum cylinder being much softer, I made a mess, the drill went everywhere but in the center, a 12mm hole ended up being tapped to 14mm. The next time this happened (I should have learned my lesson), but this time I took the cylinder to a neighbors machine shop, he put it in the milling machine, clamped it down, centered it and the endmill removed everything perfect. Only a light tap thru it and it was back to new. Of course this only works on small removable parts and a machine shop who is a neighbor and swaps his work for work on his equiptment.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Talk of the Town: Winterizin Engines - To Drain or Not to Drain? - by Staff. Another great discussion from the Tractor Talk Discussion Forum. The discussion started out with the following post: "Winter is fast approaching..for a gas tractor should the gas tank be drained and run the engine til the carb is dry or do the gas stabilizer products I've heard of work? (tractor will not be used til spring) any other tips for winterizing?? "
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
