I have changed every light in the house to LED. Started 3 years ago and finishing up last week. The brand I use has some lights that will run on 12 vdc/ac all the way up to 208 and can't remember but may be to 277. I have 2 and 4 ft. fluorescent led replacements also. They are expensive but I sure like the quality of light from them. The tubes,are shatter proof, don't need a ballast and I just remove them and trash them. Just get voltage to one end and N to the other on just one pin or all. Very simple. They use 17 watts as to 34 watts on the old style.
I buy from Earth Led and they have a chart with standard lamp wattage and can click on that and see the LED replacements for that wattage lamp.
I had one lamp to stop working and had no problem getting it replaced. The folks there have been very helpful and able to answer all my questions.
I have several lights that use 4 bulbs of regular 40 watt. I replaced them with 8 watt LED's and have better quality light. And last the power bill went down. Most of the Led's have a 3 year to pay back. They are almost all rated 50,000 hr. of this brand. 3 year replacement if one stops working.
We all know power rates will climb. I've been working on this for several years now and not just lights. What I've changed has brought my average monthly power bill from $178 per month down to $123 per month and have had 2 rate increases and fuel charge added that time frame. Prices of Leds are down now from when I started. I think they are the best bang for the buck for lighting going today.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Engine Rebuild Kit - by Curtis Von Fange. I always liked engine rebuild kits. They have all the replacement parts for overhauling an engine without going to the store to get gaskets, special measuring tools, or miscellaneous parts. They come neatly packaged, clean and tidy. But it's important not to let that packaging lull you into a false sense of security. The appearance of matching sleeves, pistons, rings, and bearings can cause frustration and agony if not properly measured and installed in a workshop environment. Following c
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.