Posted by Hal/Eastern WA on April 30, 2012 at 10:11:00 from (97.119.244.50):
In Reply to: OT Lawrence Welk posted by John T on April 28, 2012 at 19:27:03:
I started watching Lawrence Welk as a kid, because my parents wanted to watch the show, and if Welk was on, our TV would be on that channel, no matter what else I might have wanted to have on...but a funny thing: I still watch Lawrence Welk every chance I get, because I LIKE IT! I am very pleased that the shows were preserved and that PBS has them on most weeks, still on Saturday night, just like when I was growing up.
While I thought some of the skits were kind of corny, and especially in the later years, the choices of music seemed to stray from what Lawrence Welk was all about, I always enjoyed the shows. The musicians were all top notch professionals, and some of them were among the best that existed. The show was unlike anything else on the air.
It also always had a "family" feel to it, and I felt like I knew many of the performers as friends. We went to some of their live shows, and the performers came out and visited with the audience after the shows. They were just like they seemed on TV, nice and friendly.
I hope PBS will continue to broadcast Lawrence Welk shows forever, and I give them money earmarked as being for Lawrence Welk to help insure that it will continue. I do wish they would not use so many of the same shows they had on over the last couple of years. I remember the repeats that are that recent.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.