Posted by dave2 on April 28, 2012 at 03:28:50 from (139.139.35.70):
Hey,
Got this brainstorm and don't know whether to kill it or try it...
Got the OK to put up a more permanent fence at a couple of our places..
Only small areas so not a lot of posts.
Ground water is high in winter and the ground stays moist all year.
Just use a normal post, paint it with tar, and tamp it with peagravel?
My brainstorm is 6" PVC set like a post, cenented in, and filled with concrete (and hope I get my hooks etc in the right spot the first time :roll: )...... As I type this, thinking it'll be a whole lot less trouble just replacing a rotten post or two if ever needed....
So, if I use wood, locust is like hens teeth... Choices local are sawmill oak, larch, and some pines. Cut and skinned pine from the woods (maybe oak?)... and store bought pressure treated in either 4x4's or round posts...
what should I use???
Can find locust and cedar now and then but not often......
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.