Posted by Don-Wi on April 19, 2012 at 18:02:52 from (75.207.148.68):
In Reply to: Kids driving tractors posted by Keith Molden on April 19, 2012 at 09:52:16:
I started driving somewhere in the 5 to 7 range. Started raking hay, then driving the baler so Dad could stack, etc... At 14 I was running the chopper and Dad was hauling and unloading wagons.
I also hauled A LOT of manure, and quite a bit down the road. Dad would be gone to work(off the farm job), so he'd have me chip away at the manure pile. I even learned to replace drive chains and shear bolts early on.
I rode the fender all the time, espescially for cutting hay and green chopping. I always rode the left fender and the machines were offset to the right, so wasn't nearly as bad as a direct pull green chopper or mower. I always liked to ride in the green feed wagon too.
I look at my 7 year old nephew, and he's not nearly mature enough to take on that kind of responsibilty. He was starting to help in the barn, but his attention to detail, or even the job at all, goes away after the first couple days to a week. I started to give him and his younger brothers a ride here & there on the fender if I was hauling manure where I could keep an eye on them. I'll probably let the younger one drive before the older one.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
