Posted by Mike (WA) on April 18, 2012 at 08:37:32 from (69.10.196.49):
In Reply to: Who's right. posted by flying belgian on April 18, 2012 at 07:35:49:
"Interesting question", as we say in the legal biz. I'm not familiar with grain dryer setups, but it sounds like you put the wet grain in your tank, his dryer blows hot air through it, and after its dry, the auger empties your tank. Have I got it right?
On first glance, it appears that it should be your auger. But what makes it interesting is that its bolted to the dryer, and usually stuff that's bolted together goes together. Is it bolted to the dryer just as a means of support?
Guess if I were the judge on this one, I would come down on your side, because the auger is a functional part of the tank, and not the dryer- it was just bolted on as a means of supporting it. The fact that it was hard wired to the dryer means nothing, IMHO- you wire to the handiest and closest point, and of course you would wire the auger to the dryer it was next to.
Kind of reminds me of an auction I went to, many years ago- There was a yellow 3 point post driver, which I wasn't particularly interested in, but they had put all the pieces of a JD B add-on 3 point hitch with it, presumeably because they were the same color. Quandry- do I ask the auctioneer to separate them? I knew the 3 point was in more demand than the post driver, so took a chance and kept my mouth shut. Ended up getting the whole outfit for about $400, later sold the driver alone for the same- after I tried it once, and concluded that it was a good way to keep from growing old.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Ford Part Number Trivia - by Forum Participants. "Replaced by" means the part was superseded. All of my part books date back to 1964 and New Holland have changed some part numbers. They usually put the old Ford part number on the package. I was suppressed when I looked up the part number of the auxiliary drive shaft because for some reason the part number went through a radical change and it lost its "Basic Part Number". Ford part numbers follow the following rules. Most part numbers are in three parts. The middle part is called the
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.