Posted by JDseller on April 17, 2012 at 23:01:53 from (208.126.196.144):
In Reply to: paulbunyan.net posted by mn Bob on April 17, 2012 at 07:13:17:
Those three point adapters really don't work very well for plowing. The tractor was designed for the snap coupler/draft system to plow with an integral plow. The three point adapter short circuits all of that system.
So you have three choices: 1) Just keep doing what you have been doing. Manually working the lift like the draft system would. On hilly terrain this is going to be hard to do with any great success.
2) Just find a set of snap coupler plows. It is not hard to remove just the lift arms and lift links on your three point adapter. Then use the snap coupler plow. Then you will have a working draft system that actually worked well. When done plowing just reinstall the three point linkage and arms.
3) Forget an integral plow. Just go back to a pull plow. You can get a hydraulic lift plow. If your not needing to plow much then just get a two bottom and that WD will pull them anywhere. A three bottom will be a tough pull in hard to plow soils. You will run out of traction. A good pull plow does a great job plowing when set correctly. I have a set just for little spots just to keep from having to move wheels and such.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Oliver 550 Clutch Overhaul Tips - by Greg Sheppard. I got my 1964 Oliver Model 550 (serial 141-139-519) second-hand and used it for several years before the clutch began to slip. After taking up the pedal linkage several times I saw it was going to take more than that. The engine had been leaking oil at the rear seal and I suspected
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
