I have 4 morton buildings, which I call pole barns. They put a treated post directly into the ground. Our oldest one has creosote 6X6 posts, and the newer ones are three 2X6's nailed together staggered to make posts. They all rot the same. They last about 20 years before they rot off. My soil is clay, wet at the bottom, but they don't rot at the bottom. They rot just below the surface. It's a combination of moisture and air that creates the environment for rot. It's the same with both the solid creosote and the 2X5 build up with later treated.
Recently I repaired some posts because I was rennovating one barn. I dug down and removed the lower rotted off portion, and carefully removed the built up 2X6s up til I had all good wood. then I built up the repair section from treated wood, and installed a plastic "Post Protector" on the bottom. Then I installed the new piece to the post. As long as teh post protector is on the inside and you are not getting water down into the post protector, I think this will far outlast the life of the original post. This is what they should be doing with all new morton buildings if they aren't already. It's cheap protection. On the other hand, it might make the buildings last longer than Morton would like for sales purposes. Here's a before and after. Yes, I had cut open the concrete and then repaired it after. I was converting this open barn section into an enclosed area. this post was 90 percent rotted off.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - 12-Volt Conversions for 4-Cylinder Ford 2000 & 4000 Tractors - by Tommy Duvall. After two summers of having to park my old 1964 model 4000 gas 4 cyl. on a hill just in case the 6 volt system, for whatever reason, would not crank her, I decided to try the 12 volt conversion. After some research of convert or not, I decided to go ahead, the main reason being that this tractor was a working tractor, not a show tractor (yet). I did keep everything I replaced for the day I do want to restore her to showroom condition.
... [Read Article]
Latest Ad:
1958 FORD RARE 4x4 801 TRACTOR, ELENCO/FRONT DRIVE, FRONTLOADER AND WEIGHTED REAR WHEELS, FIVE SPEED, LIVE PTO, GAS ENGINE, NEW REAR WHEELS AND TIRES, ENGINE RUNS.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
