Brad -- A well will be drilled down to reservoir depth gradually building angle to roughly 80-90 degrees with a bent housing mud motor, usually around 1 1/2 degree of bend,a mud motor is a tool with a stator inside that works similar to a hydraulic motor, when fluid is pumped through the mud motor at high pressure and volume the stator turns the bit. After reaching the horozontal point normally a more advanced mud motor that can be surface contolled or steered by a computer is used. In 99% of the wells the same drill pipe is used that would be used in a straight hole, the pipe its self is very limber in long sections and can be pushed with no problem. Basically, the drill string components that are normally used right above the bit for drilling weight when drilling a straight hole are moved up in the vertical section to push the lower limber section when drilling horozontal.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Dad's Old Silver King and Joe Capalco - by Woody E. Diehl. My father, Charles Diehl, grew up in the Elsworth, Ohio area during the Depression on a small working farm. I never saw the place, nor was I around during his early years. What I know about those hard times comes from listening to Dad and his old pals reminisce from time to time. One of the old timers that would sit with Dad and chew the fat about the 'good ole days' was Joe Capalco. Joe wasn't like most of my Dad's friends. He rarely worked that we knew of. Always had plenty of time
... [Read Article]
Latest Ad:
Late 50s early 60s international harvester 560 with cultivator
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
