Posted by dej(Jed) on April 12, 2012 at 10:39:07 from (141.189.113.1):
In Reply to: Welding Cast Iron posted by 37Chief on April 11, 2012 at 22:00:48:
Quoting Removed, click Modern View to see
I have had a lot of luck welding engine block pieces in with Ni rod. It took
a bit of instruction, but what I was taught is as follows. I would heat a section of the block and piece cheery red with a torch. Don't try to heat the whole thing, but about a 6 to 8 inch section. Next weld the section with the Ni rod and then immediately cool it with a sponge and cold water.
Next move on and repeat the process until the whole patch is in place and welded. Cast is porus and the heating seems to facilitate the weld holding. If I just welded , the weld would split as it cooled .
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Good As New - by Bill Goodwin. In the summer of 1995, my father, Russ Goodwin, and I acquired the 1945 Farmall B that my grandfather used as an overseer on a farm in Waynesboro, Georgia. After my grandfather�s death in 1955, J.P. Rollins, son of the landowner, used the tractor. In the winter 1985, while in his possession the engine block cracked and was unrepairable. He had told my father
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
