Posted by JDseller on April 11, 2012 at 21:14:18 from (208.126.196.144):
In Reply to: SR1911 posted by Red Mud on April 11, 2012 at 14:14:35:
I got five of them a year ago. I had ordered them three years ago before they even went into production. I wanted them to give to my kids. I did have a local gun smith work them over to match quality. The quality on delivery was not great. The trigger pull was vastly different between the five guns. The slide action was terrible on two of them. They would jam once every time in shooting a ten round clip.
The kids where thrilled with them. They could brag them up. The pistols do look good.
Would I buy another Ruger after these??? A big maybe. I have a lot of older Ruger firearms and they are good quality. The newer stuff has been cheapened up too much.
I have a pair of 1911 Colt 45ACP pistols that my Dad bought for me while I was in Vietnam. They cost $750 dollars in 1968. They where match grade pistols. I was told they where hand built from the best matching set of parts. Several gun smith/dealer friends have told me they have heard of Colt making these pistol but had never seen a set because of the high selling cost. I guess very few where ever sold.
They are the smoothest semi-automatic pistols I have ever shot. I have carried them ever since then. The one is just a little more accurate than the other. That one has had over 17,000 round fired through it. I keep a diary of every round that has been fired through them.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Sunday Drives - by Cowboy. Summer was finally upon us here in Northern Maine. We have two types of industry up here, one being "Forestry" (Wood Products) and the other "Farming" (Potatoes). There is no shortage of farm tractors and equipment around here! I have been restoring old Farm Tractors for the past 6 years, and have found it easier and less expensive to hit all the auctions and purchase whole tractors for parts needed. My wife who works at a local school, and only has weekends and summers off, while on t
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
