Posted by Ralph Bauer on April 09, 2012 at 13:51:10 from (75.107.19.155):
In Reply to: Re: gas price hike... posted by IndianaRed on April 09, 2012 at 12:26:24:
Indiana Red, it looks like you didn't understand the meaning of my post at all even though I "signed" it with "A sarcastic Ralph in OK" and that I pointed out that ".....that's what I would do, too,...." As far as the reserves are concerned, sure, there's plenty, never disputed that, but the fact I pointed out is that a large portion of US oil is exported, and we import at the same time the other portion (to make up 100% of our need)because doing it that way makes the most money to the oil companies. Therefore independence from foreign oil will not happen. (True independence would be reached by producing 100% of our domestic oil needs AND keeping it here with no imports of oil from abroad.)Hope this clarifies it a bit more. Your "lefty kook" Ralph from Oklahoma.lol
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.