Posted by MeAnthony on April 04, 2012 at 16:42:18 from (74.204.60.50):
My oldest son got laid off here in Michigan. His girlfriend's younger sister needed a ride to Beverly Hills, FL. He has the time, and her mom was buying the gas, so he said he'd take care of it for them.
They got there yesterday evening, no problems. Today he calls me at work, problem with the truck. Got it to a garage, right front caliper is intermittently hanging up, pads shot, rotor needs to be turned. The garage is quoting him about $350 to replace both calipers, turn both rotors and replace the pads.
The truck is a '99 Dakota, 2 wheel drive, so it's a fairly simple job. I could talk him through it on the phone but he has no place to work on it and no tools.
Then he tells me that his girlfriend's mom has apparently run out of cash and he doesn't know if they will have gas money to come back. Sounds like she sent two debit cards with them, one stopped working on the way down(assuming no funds to back it), the other one is overdrawing it's account.
So, short summary: he's 1100 miles from home, has his girlfriend, two of her sisters and a friend of one of the sisters with him(having 4 teenage girls in the truck would probably drive me nuts). A busted truck and maybe no money left to get back to Michigan.
I told him to start checking for jobs, might be able to pick up a few days work. Could be his only option. Y'all have any ideas?
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.