James has posted some pictures below of the bahia. Thickness or sparsity is generally a function of the type of soil and the nutrient level in the soil. Low nutrients = sparse grass.
After doing some research on the internet, we chose the Tifton 9 because of its hybrid qualities.
We were able to plant only a small area with Tifton 9 this year because be had a bag left over from the planting last year. We wanted to plant some other areas this year with T9, but because the cost more than tripled, $250 to $300 per 50 lb bag, we will be planting pensacola bahia.
Our soil is sandy loam. I don't know if bahia would do well in heavy clay. I would suggest you google it and read the info on soil types. You could also contact your county's agricultural extension agent. They are a good source of info.
Rotary hoes were originally used to control weeds in crops. They were to be pulled as quickly as possible. They worked best when the weeds were small and they would literally uproot them and flip them up in the air. That's why they were to be pulled quickly so the tines would flip the weeds up.
We used it not only to uproot the small weeds that were coming up, but to loosen the top layer of soil before planting. Rotary hoes were not intended to go very deep in the soil, a couple of inches at best. I don't know how well they would work in heavy clay. Since they were designed as a weeding device, I don't think you would want to use it in an established pasture as it would probably damage the forage grasses already there.
We purchased our seed from the Co-op in Sulphur Springs, Tx. We can give you the phone number if you want it.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Massey Ferguson 35 (and up) Tractor Assembly Notes - by Jack Wetmore. These assembly notes are for Massey Ferguson tractors with a two stage clutch and 6 speed, 8 speed and mutli-power transmissions. I see a lot of discussion forum messages regarding damaged clutches from improper assembly. The objective is to have the engine and transmission slide together safely and easily until the gap between the two halves is less than 1/4", BEFORE tightening any of the bolts holding the two together. Using bolts to draw the two halves together will damage the PTO
... [Read Article]
Latest Ad:
1 SD Gibson, 1 D Model needs rear end assembled and installed, 1 D Model needs minor repairs, extra parts
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
