Posted by Oliverguy on March 19, 2012 at 16:39:21 from (75.149.65.181):
In Reply to: How much longer? posted by rrlund on March 19, 2012 at 06:57:50:
Wow, that is a racket. We have a lot of small engines around here for my "real job". Where I buy parts for them, they get me bearings for about all my farm stuff and it's a heck of a lot better deal than NAPA or some place like that. I would of thought it was a $20-25 bearing. The bearings for the coulters on my DMI ripper were $15, bought wheel bearings from them for my JD planter and field cultivator also. Is someone around that's an Oregon dealer? You're right on the price of parts though. I have an old 475 disk that isn't worth putting new blades on I think. Should just look for one at a sale with good blades and scrap mine.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.